Rockwell Automation 1746-HSCE High-Speed Counter Module Installation Instructions - Manual (Page 10)

10 High-Speed Counter Module
Publication 1746-IN011C-EN-P - April 2005
Install the Module
Installation procedures for this module are the same as for any other discrete I/O or
specialty module.
1. Align the full-size circuit board with the chassis card guide. The first slot of
the first chassis is reserved for the CPU.
2. Slide the module into the chassis until the top and bottom latches are
latched.
Make sure the removable terminal wiring block is attached to the module
and all wires are connected to the terminal block.
3. Insert the cable tie in the slots and secure the cable.
4. Cover all unused slots with the Card Slot Filler, Catalog Number 1746-N2.
IMPORTANT
Set the dip switches before installing the module.
ATTENTION
Disconnect power before attempting to install, remove, or wire
the module.
Make sure your SLC power supply has adequate reserve current
capacity. The module requires 320 mA at 5V dc.
Card
Guide
Top and Bottom
Module Release(s)