Rockwell Automation 1790-TXXXX Digital Expansion Terminal Block Compact Block LDX I/O User Manual
Page 7
Advertising
7
Publication 1790-IN005B-EN-P - April 2003
Panel Mounting
1. On the panel, position the expansion block next to your
previously-installed base block.
2. Gently pull and position the expansion covers inward.
3. Place a center punch, nail or similar device through the
mounting holes in the block (lower left and upper right
corners of the module) and make two marks on the
panel.
4. Remove the block and drill two holes in the panel to
accommodate each of the mounting screws.
5.
Replace the block on the panel and place a screw
through each of the two mounting holes. Tighten the
screws until the block is firmly in place.
CompactBlock LDX
1790-16BVO
X
EXPANSION UNIT
16 INPUTS-DCPOWER
0
7 0
7
41 mm
1.6 in
95 mm
3.74 in
Expansion
Cover
Advertising