Displaying dns zone and hosts – Brocade Communications Systems ServerIron ADX 12.4.00 User Manual
Page 182
170
ServerIron ADX Global Server Load Balancing Guide
53-1002437-01
Displaying GSLB information
1
Displaying DNS zone and hosts
To display information about the DNS zones and host names that you have configured the GSLB
ServerIron ADX to globally load balance, use either of the following methods.
NOTE
There are two examples of this command line output shown below. The output differs depending on
the ServerIron ADX device you are using and the software release installed on the ServerIron ADX.
NOTE
If you also want to display information about the site and ServerIron ADX on which a VIP is
configured, use the show gslb dns detail command instead. Refer to
To display information about all the DNS zones and host applications configured on the GSLB
ServerIron ADX, enter the following command at any level of the CLI.
ServerIronADX(config)# show gslb dns zone
Flashback DNS resp.
delay selection
(x100us) percentage
TCP APP (%)
* 209.157.22.227: dns v-ip ACTIVE N-AM. 6 60 40
* 209.157.22.228: dns v-ip ACTIVE N-AM. 3 30 60
* 210.224.100.5: dns real-ip DOWN ASIA -- -- 0
* 201.100.100.6: dns real-ip DOWN S-AM. -- -- 0
* 213.34.100.4: dns real-ip DOWN EUROPE -- -- 0
HOST: ftp:
Flashback DNS resp.
delay selection
(x100us) percentage
TCP APP (%)
* 209.157.22.103: dns v-ip ACTIVE N-AM. 6 60 40
* 209.157.22.104: dns v-ip ACTIVE N-AM. 3 30 60
* 210.224.100.7: dns real-ip DOWN ASIA -- -- 0
* 201.100.100.8: dns real-ip DOWN S-AM. -- -- 0
* 213.34.100.9: dns real-ip DOWN EUROPE -- -- 0
Syntax: show gslb dns zone [<name>]
The <name> parameter specifies the zone name.
To display GSLB information for a specific DNS zone, enter a command such as the following:
ServerIronADX(config)# show gslb dns zone brocade.com
The information is the same as the information displayed when you do not specify a zone name,
except the ZONE field is unneeded and thus does not appear.
This display shows the following information.