Rockwell Automation 2361 Bridge Fan and Capacitor Replacement - Manual

Publication 2361-5.16 April 1999
Replacement Kit Instructions
Bridge Fan and Capacitor Replacement
(for 1250 and 1650A 1395 DC Drives)
Contents This document shows how to remove and replace a bridge fan and fan
capacitor in a 1250 or 1650A 1395 DC drive.
What This Kit Contains Using the table below, verify that you have received the appropriate items in
your kit:
Other Items Needed Before you begin, be sure you also have the following:
•
Tools you will need for:
– Measuring voltages (multimeter)
– Removing and fastening screws and nuts (slotted screwdriver, ratchet
with extension, 3/8” socket)
– Torquing screws (torque wrench for 20 lb-ft / 27 N-m)
– Drilling holes (drill with 1/8” bit)
•
Documentation:
– Your drive system schematics
– Publication 1395-5.40, Bulletin 1395 Digital DC Drive–User Manual
– Publication 2361-5.01, Bulletin 1395 Digital DC Drive in Bulletin
2361 Motor Control Center for Drive Systems–User Manual
!
ATTENTION: Both the bridge fan and the fan capacitor must
be replaced together when installing this kit. Equipment failure
or equipment damage may result if only one item is replaced.
For this part: You should receive this quantity:
bridge fan 1
capacitor 1
wire harness 1
mounting bracket 1
mounting screws 2
wire harness