Rockwell Automation 2361 Bridge Fan and Capacitor Replacement - Manual (Page 6)

Publication 2361-5.16 April 1999 PN 192461
Supersedes Publication 2361-5.16 - June 1998 Copyright 1999 of Rockwell International Corporation. Printed in the USA
Installing the New Bridge Fan 1. Secure the new bridge fan to the mounting bracket with its four
mounting screws. Torque to 20 lb-ft (27 N-m).
2. Secure the mounting bracket to the unit with its four mounting screws.
Torque to 20 lb-ft (27 N-m).
3. Connect the fan power connector as shown in Figure 1.
4. Install the fan inlet cover and secure it to the unit with its four mounting
screws. Torque to 20 lb-ft (27 N-m).
Concluding Steps After installing the new bridge fan and bridge fan capacitor, replace all
Lexan shielding to the unit. Check the unit for any tools or debris, then
close the bay door. Discard any damaged parts according to your company
procedures and local ordinances.
Lexan is a trademark of General Electric Corporation