Rockwell Automation 6177R-Mxxx Industrial Non-display Computers - Manual (Page 15)

Industrial Non-display Computers 15
Rockwell Automation Publication 6177R-IN001G-EN-P - July 2013
Connect Peripherals
The illustration shows the I/O port panel of the computers. Peripheral components compatible
to each port are marked inside the callout figures.
Connect AC Power
A standard IEC 320 power cable provides power to the computer. The power supply input
accepts 120…240V AC.
Operate the computer in an industrial or control room environment, which uses some form of
power isolation from the public low-voltage mains.
ATTENTION: Connect the AC power cable to a power source with an earth ground to prevent
electrical shock. Failure to follow this warning could result in electrical shock.
We recommend that the computer circuit has its own disconnect. Use an uninterruptible power
source (UPS) to protect against unexpected power failure or power surges.
Always shut down the operating system before removing power to minimize performance
degradation and operating system failures.
DVI available for
650R only.