BT Internet Radio - Manual (Page 7)

7
Internet Radio – New Style – Edition 5 – 21.09.06 – 7690
3. Connect to the wireless network
With the name for the access point you want to connect to
displayed, press
Select .
If your network is not configured to need an encryption code,
the display should show
Connecting to network
, then
Network OK
.
If the screen displays either
Enter WEP key
or
Enter WPA
key
, then the network is using one of the encryption systems:
WEP or WPA and you will need to enter the correct code to
enable the radio to communicate with your network.
After about 3 seconds, the display goes into the code entry
mode. To enter the code, use the tuning dial to select each
character of the code in turn, pressing
Select after each
character.
When you have entered the final character, use the tuning
dial to select
END
and press Select .
The radio should now be able to connect to the network.
4. Connecting a headset (optional)
Connect the headset plug into the socket marked on the
side of the radio.
Your BT Internet Radio is ready for use.
The WEP or WPA code would have
been set up by the person who set up
and configured your wireless network.
Getting started
WEP and WPA codes are sensitive to
upper and lower case characters so
you must enter them exactly.
Make sure the character you want is
shown in the centre of the display
before you press Select .