Rockwell Automation 1440-TBS-J XM Dynamic Measurement Module Terminal Base - Manual (Page 12)

12 XM Dynamic Measurement Module Terminal Base
Publication ICM-IN003D-EN-P - March 2013
Install the Terminal Base
The terminal base can be DIN rail or wall/panel mounted.
Mount on a DIN Rail
Follow these steps to mount the terminal base on the DIN rail.
1. Position the terminal base unit on the 35 x 7.5 mm DIN rail (A) (A-B
pt no. 199-DR1 or 199-DR4) at a slight angle.
WARNING
If you insert or remove the module while backplane power is on, an electrical
arc can occur. This could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
ATTENTION
Do not remove or replace a terminal base unit while power is applied.
Interruption of the backplane can result in unintentional operation or machine
motion.
31887-M
B
A
A
Position terminal base at a slight angle and hook over the top of the DIN rail.