Rockwell Automation 1440-TBS-J XM Dynamic Measurement Module Terminal Base - Manual (Page 15)

XM Dynamic Measurement Module Terminal Base 15
Publication ICM-IN003D-EN-P - March 2013
Panel/Wall Mounting
Installation on a wall or panel consists of:
• laying out the drilling points on the wall or panel.
• drilling the pilot holes for the mounting screws.
• installing the terminal base units and securing them to the wall or
panel.
Follow these steps to install the terminal base on a wall or panel.
1. Lay out the required points on the wall/panel as shown in the drilling
dimension drawing below.
Maintain at least 25.4 mm (1.0 in.) air space around your XM system
installation.
2. Drill the necessary holes for the #6 self-tapping mounting screws.
3. Secure the terminal base unit using two #6 self-tapping screws.
4. To install another terminal base unit, retract the side connector into
the base unit; make certain it is fully retracted.
40.10
[1.577] 35.51
[1.398] 23.50
[.925]
94.01
[3.701]
Screw hole for
panel/wall
mounting.
Grounding
screw hole
for panel/
wall
mounting.