Rockwell Automation 1440-TBS-J XM Dynamic Measurement Module Terminal Base - Manual (Page 13)

XM Dynamic Measurement Module Terminal Base 13
Publication ICM-IN003D-EN-P - March 2013
2. Slide the terminal base unit over leaving room for the side
connector (B).
3. Hook the lip on the rear of the terminal base onto the top of the DIN
rail, and rotate the terminal base onto the rail.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail.
If the terminal base does not lock into place, use a screwdriver or
similar device to open the locking tab, press down on the terminal
base until flush with the DIN rail and release the locking tab to lock
the base in place.
5. Connect the wiring for the terminal base unit as shown under Wiring
later in this document.
31883-M