Ambient Lanc Logger - ALL601 - Manual (Page 12)

12
Menu Bar
When a menu is selected with ENTter then the Menu select bar appears The
menu title moves to the left position and submenu details to configure, appear
on the right. Submenu details can be selected with left or right cursor and
ENTter. SYS and battery symbols disappear to make room for menu
parameters. ESCape returns to the JOB bar with battery and SYS symbols.
When all menus have been configured, ESCape returns to the JOB bar.
The job is “closed” by pressing the two inner cursor tabs together, ie. “closing
the doors”.
In “doors closed” the JOB tab ceases blinking and no parameters can be
changed, but one can view the parameters selected in the menus by moving to
the menus with the left and right cursor keys. The parameters selected, or
being processed by the ALL are shown under the menu selected.
The JOB can then begin without danger of changing parameters by inadvertent
pressing of the keys.
To change a parameter during a job ie. Cassette number increment, first press
the two outer Cursor keys simultaneously thus “ opening the doors. The JOB
tab will blink and parameters can be changed. Then the doors can be closed.
Always run a job with doors closed.
Note: See LOG job, Mode menu for quickkey cassette number increment.
Note: The job can only be closed when the job bar is shown and the JOB
selected (left) is blinking. Conversely the job can only be opened when the Job
bar is displayed and the Job selected is not blinking!