Autocue Digital Cue Light Kit - Autocue QTV - Manual

Guide
Digital Cue
Light Kit
A
Note: If there is not a camera tally light available, the tally
output socket that is fitted to most cameras can be used.
Remove the sensor head and fit compatible plug. (The two
conductors in the sensor cable need to be shorted to make
the cue light operate)
Cue Light Controls
Note: This step is not
required if the unit is
connected to the Tally
out socket.
autocue.com
Socket Pin out Note
Power Input Pin 1- / Pin 6+ 12v DC / 0.02mA
Sensor Input Pin 1 and 2 Short for operation.
Sensor Mounting
8. Attach the self-adhesive
Velcro disc to the on camera
tally and secure the sensor to
the disc.
9. Plug in the power cable into the sensor socket. This will
provide power to the cue Light. This socket is only available
on the MSP range of monitors.
For use with the PSP range of monitors an additional 12V
DC power supply will be required.
11. Rotate this control until the desired camera
number is displayed.
10. The Trim Control adjusts the sensitivity of the sensor.
To set the level ensure that the on camera tally light is on
and the sensor is in place. Rotate the control clockwise
until the display changes from green to red. The sensor is
now set.
Connector Specifications