Maintenance, Cleaning the monitor, Care and handling advice – Autocue TFM09 User Manual
Page 14
www.qtv.com
11
www.autocue.com
Issue
#
: 081
017
©
2003
-200
8
Au
to
cu
e Grou
p Ltd
Section 7: Troubleshooting and Maintenance
Maintenance
Cleaning the monitor
TFM09
Assembly and Installation
Guide
For further troubleshooting assistance, refer to our Frequently Asked Questions
(FAQ) database on our website: www.autocue.com.
7.2: Maintenance
7.2.1: Cleaning the monitor
C
AUTION
:
Electric Shock Hazard!
Isolate the feedback monitor and any other devices from any power
source before cleaning the display unit surface.
Regular cleaning will help keep your feedback monitor in good condition.
•
As recommended by the manufacturers, use tepid water with a
small amount of detergent to clean the glass on the prompter
display unit and then leave it to dry naturally.
•
Wipe the equipment surface down with a moist cloth; do not
allow liquid to enter the equipment.
•
Clean the feedback monitor screen with a lint-free, soft cloth. Do
not use (glass) cleaning agents or paper tissues for cleaning.
•
Wait until all cleaned parts are completely dry before
reconnecting the feedback monitor to the power source.
7.2.2: Care and handling advice
•
Avoid dropping the feedback monitor or any of its individual
components.
•
Clean the monitor periodically.
Select the H-Total and Phase functions from
the Position menu and change the settings to
achieve a sharp and stable image (these
settings may have to be repeated when you
have selected another graphics mode).
The image is not sized properly or
not centered
if the horizontal and vertical image position in
the OSD menu is set correctly
If the selected graphics mode is appropriate
if the display unit supports the graphics mode
of the graphics board
OSD error message: "Signal
overrange”
if the selected graphics mode is correct.
if the display unit supports the graphics mode
of the graphics board
Problem
Check...