Bang & Olufsen BeoCenter 6-23 - User Guide - Manual (Page 17)

17
Use your pincode
If your television has been disconnected from
the mains for 15–30 minutes, the television
prompts you for the pincode when you
switch it on. You may not be able to switch
the television on immediately – wait
approximately 30 seconds and try again.
IMPORTANT! If you are prompted for a pincode
the first time you switch on your television,
contact your Bang & Olufsen retailer.
When your television is switched on …
> Enter the code digits using the number buttons
or .
> Press GO when the last digit is entered.
> Your television starts up again.
Five incorrect entries will cause the television to
shut down for three hours, during which
operation is not possible.
If you have forgotten your pincode …
> Contact a Bang & Olufsen retailer to receive a
five-digit mastercode.
> When the television prompts you for your
pincode, press and hold to bring up the
MASTERCODE menu.
> Entering the code digits using the number
buttons or and pressing GO will deactivate
your pincode and reactivate your television.
To use the pincode system again …
> Follow the procedure for activating the pincode
system.
PINCODE
next
accept GO
PINCODE 0 . . .
MASTERCODE
next
accept GO
MASTERCODE 0 . . . .
NOTE! Should you lose or forget your code,
contact your Bang & Olufsen retailer. Your retailer
can provide you with a mastercode, which
disables your pincode.
3507791_0604UK UG BeoCenter 6-23.indd 17 05/04/06 14:15:47