Bendix Commercial Vehicle Systems TABS-6 ADVANCED SINGLE CHANNEL - Manual (Page 34)

34
ECU Part Number Label
The external part number label is located above the control
port of the module. If this label is not readable for any
reason, the Bendix part number is etched into the module
casting above the control port (See Figure 1). A Bendix
manufacturing date code is to the right of the part number
inscription.
There is an additional label under one of the covers that
shows a pin-out diagram for the 18-pin main connector.
FIGURE 36 ‑ lABel informATion
Software Revision Level
The number of the initial software loaded on the ECU is
also indicated. The current software revision number can
be read using a diagnostic tool.
Document Revision Level
Please visit Bendix.com to ensure you have the latest
version of this document.
Date of Manufacture Code
Bendix Part Number
YYWWDAAAAYYWWD
AXXX
Knorr-Bremse 00 A
K004243
XXXXXXXX
Final 8 Digits
Show Initial
Software
Loaded