Bendix Commercial Vehicle Systems TABS-6 ADVANCED MC SD SHEET - Manual (Page 19)

19
1st
Digit
2nd
Digit
Diagnostic Code
Description
Possible Causes / Repair Information
J1587
(SID/
FMI)
J1939
(SPN/
FMI)
11 8
Auxiliary Electrical
Error #4
• Clear diagnostic codes.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
152/12 612/12
11 9
Auxiliary Program
Error – ADL
• Verify that the Auxiliary I/O ECU pin-outs match the ADL parameters
using the Bendix ® ACom ® diagnostic software (version 6.1 or higher).
• If necessary, contact your local Bendix representative to troubleshoot
the ADL program.
152/12 612/12
11 10
Low Supply
Pressure
• Check if the trailer’s service reservoir pressure is < 75 psi
(5.2 bar).
• If the trailer’s service reservoir pressure is > 75 psi (5.2 bar):
 Cycle Ignition power “OFF” and “ON”.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the Bendix ® TABS‑6 ™ Adv MC
module.
152/01 612/01
11 11
WL (Indicator Lamp)
Information – ADL
• Verify that the ADL parameters are correct using the Bendix ® ACom ®
diagnostic software (version 6.1 or higher).
• If necessary, contact your local Bendix representative to troubleshoot
the ADL program.
152/14 612/14
Miscellaneous
12 1
Service Distance or
Date Exceeded
• Perform scheduled trailer maintenance and/or reset the Service
Distance or Date.
• Perform the Installation Test using the Bendix ACom diagnostic
software (version 6.1 or higher), or Bendix ® Trailer Information
Module.
153/00 612/00
12 2
Trailer Load Out of
Range
• If trailer is equipped with a raise/lower valve, verify it is in the drive
position.
• Verify that the ECU parameters for the empty and fully loaded trailer
conditions are correct using the Bendix ACom diagnostic software
(version 6.1 or higher ), or Bendix Trailer Information Module.
• If necessary, contact your local Bendix representative to troubleshoot
the trailer’s loading condition.
069/13 1059/13
12 3 Brake Pads Worn
• Manually check the condition of the pads on each brake to determine
if any require replacement.
• If no pads require replacement, check the wear sensors and cables
for damage or defects.
070/01 1060/01
12 4
Low System
Pressure, P1
• Check if the trailer’s service reservoir pressure is < 65 psi
(4.5 bar).
• If the trailer’s service reservoir pressure is > 65 psi (4.5 bar):
 Cycle Ignition power “OFF” and “ON”.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
254/11 1086/11
12 8
Trailer Information
Module Missing
• Trailer Information Module and/or harness damaged or not present. 254/11 0/11
Mechanical Load Sensor
13 4 Load Sensor Error
• (Spring Suspension Systems) Inspect the linkage: Check that the
linkage is attached to the axle, inspect for damage to the linkage
components, loose connectors and mis‑installation.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
69/13 0/13
Diagnostic Trouble Codes
(DTCs)
(continued)