Bendix Commercial Vehicle Systems WINGMAN ACB ACTIVE CRUISE W/BRAKING - Manual (Page 25)

25
5.0 OTHER SYSTEM FEATURES SECTION
Section Index
5.1 Reading Bendix ® Wingman ® ACB
System Key Indicators . . . . . . . . . . . . 25
5.2 Diagnostic
Trouble Code (DTC) Self Clearing . . . . . . . 25
5.3 Following Distance Adjustment Switch
(Optional) . . . . . . . . . . . . . . . . . . . 25
5.4 Confi guring Wingman ACB Following
Distance Alerts . . . . . . . . . . . . . . . . . 26
5.5 Extracting Bendix ® Wingman ® ACB
System Data. . . . . . . . . . . . . . . . . . 27
5.5.1 Data Availability . . . . . . . . . . . . . . . . 27
5.5.2 Data Overview . . . . . . . . . . . . . . . . . 27
5.5.3 Extracting Data and Saving a Report . . . . . 27
5.1 READING BENDIX ® WINGMAN ®
ACB SYSTEM KEY INDICATORS
To check the Bendix ® Wingman ® ACB system key
indicators such as software version number, Bendix ®
ACom ® Diagnostics version 6.3 or higher, must be used.
From the main menu of ACom Diagnostics software, the
technician highlights ACB, then clicks “Start with ECU”.
The ACB Status screen will appear. Clicking “Confi g” will
display the key system indicators. See Section 4.21 for an
example of reading the software version. See Figure 17 for
an example of ACom software con
fi guration information.
See Appendix D.
NOTE: ACom ® Diagnostics is also used for troubleshooting
Bendix ® ESP ® , ATC, and ABS systems.
FIGURE 17 - BENDIX ® ACOM ® SCREEN SHOWING
CONFIGURATION NUMBER
5.2 BENDIX ® WINGMAN ® ACB DIAGNOSTIC
TROUBLE CODE (DTC) SELF-CLEARING
Many of the diagnostic trouble codes (DTCs) will auto-
matically clear when the cause of the problem is corrected.
When the technician troubleshoots a diagnostic trouble
code, it is recommended that the Bendix
® ACom ® Diag-
nostics (version 6.3 or higher) service tool be used to
clear the diagnostic trouble codes as directed by the repair
procedure.
Some codes will clear immediately and the functionality
will resume. Some codes will clear after powering off the
ignition for about 15 seconds and then turning it back on.
Other codes will clear after the engine runs for about 15
seconds.
If the vehicle’s cruise control can be engaged, that indicates
all Wingman ACB trouble codes have been cleared.
5.3 FOLLOWING DISTANCE
ADJUSTMENT SWITCH (OPTIONAL)
If the vehicle is equipped with the following distance
adjustment switch and the following distance does not
change after an adjustment is made, the switch, wiring,
or a controller on the vehicle should be checked using
the diagnostic procedures described by the vehicle
manufacturer. The radar sensor receives the driver’s
desired following distance on the J1939 data communication
link from a controller on the vehicle. No diagnostic trouble
code will be set if the vehicle is not equipped with a following
distance adjustment switch.