Bendix Commercial Vehicle Systems WINGMAN ADVANCED FLR20 SENSOR - Manual (Page 28)

28
5.0 OTHER SYSTEM FEATURES SECTION
Section Index
5.1
Reading Bendix ® Wingman ® Advanced ™
System Key Indicators . . . . . . . . . . . 28
5.2 Diagnostic Trouble Code (DTC)
Self-Clearing . . . . . . . . . . . . . . . . . 28
5.3
Following Distance Adjustment Switch
(Optional) . . . . . . . . . . . . . . . . . . 28
5.4
Configuring Wingman Advanced Following
Distance Alerts . . . . . . . . . . . . . . . . 29
5.5 Extracting Bendix Wingman Advanced
System Data . . . . . . . . . . . . . . . . . 30
5.5.1 Data Availability . . . . . . . . . . . . . . . 30
5.5.2 Data Overview . . . . . . . . . . . . . . . . 30
5.5.3 Extracting Data and Saving a Report . . . . 31
5.1 READING BENDIX ® WINGMAN ®
ADVANCED ™ SYSTEM KEY INDICATORS
To check the Bendix Wingman Advanced system key
indicators such as software version number, use a current
version of Bendix ® ACom ® Diagnostics software. From the
main menu of ACom Diagnostics software, the technician
highlights Advanced, then clicks “Start with ECU”. The
Advanced Status screen will appear. Clicking “Config” will
display the key system indicators. See Section 4.21 for an
example of reading the software version. See Figure 17 for
an example of ACom software configuration information.
See Appendix H.
NOTE: ACom
® Diagnostics is also used for troubleshooting
Bendix ® ESP ® , ATC, and ABS systems.
FIGURE 17 - BENDIX ® A COM ® SCREEN SHOWING
CONFIGURATION NUMBER
5.2 BENDIX WINGMAN ADVANCED
DIAGNOSTIC TROUBLE CODE
(DTC) SELF-CLEARING
Many of the diagnostic trouble codes (DTCs) will
automatically clear when the cause of the problem is
corrected. When the technician troubleshoots a diagnostic
trouble code, it is recommended that a current version of
the Bendix ® ACom ® Diagnostics software be used to clear
the diagnostic trouble codes as directed by the repair
procedure.
Some codes will clear immediately and the functionality
will resume. Some codes will clear after powering off the
ignition for about 1 minute and then turning it back on.
Other codes will clear after the engine runs for about 15
seconds.
If the vehicle’s cruise control can be engaged, that indicates
all Wingman Advanced trouble codes have been cleared.
5.3 FOLLOWING DISTANCE ADJUSTMENT
SWITCH (OPTIONAL)
If the vehicle is equipped with the following distance
adjustment switch and the following distance does not
change after an adjustment is made, the switch, wiring,
or a controller on the vehicle should be checked using
the diagnostic procedures described by the vehicle
manufacturer. The radar sensor receives the driver’s
desired following distance on the J1939 data communication
link from a controller on the vehicle. No diagnostic trouble
code will be set if the vehicle is not equipped with a following
distance adjustment switch.