Bendix Commercial Vehicle Systems WINGMAN ADVANCED FLR20 SENSOR - Manual (Page 40)

40
Appendix C
Bendix ® FLR20 ™ Radar Alignment
C1 LATERAL ALIGNMENT USING THE BENDIX ® ALIGNMENT CLIP AND TOOL
This is the method to use for lateral alignment when a radar and/or bracket is replaced.
Tools needed: Bendix ® alignment kit, steel clip, Torx T-20 screwdriver and a tape measure.
• One of the Bendix ® Alignment Tools part no: K065284 and K096579 — available from Bendix parts outlets — are used.
The alignment procedure also requires a steel clip, part number K073087.
Alignment Tool
with Laser
Guide
K065284
Magnetic Feet
(3)
K096579
Shorter
Bar
Install Steel Clip
over FLR20
Steel Clip
(actual design may vary)
ALIGNMENT TOOLS AVAILABLE
C1.1 Park the vehicle on a level floor. Air suspensions must be charged and stable. Install the steel clip supplied
over the radar sensor.
C1.2 Attach the alignment tool onto the clip using its magnet feet. Inspect to make sure that the alignment tool is
approximately horizontal width-wise.
C1.3 Activate the lateral alignment laser light “on” switch. Place the tool into position for the first measurement.
(The tool will be reversed when the second measurement is made.)
APPENDIX C - RADAR ALIGNMENT USING BENDIX ® ALIGNMENT CLIP AND TOOL
Appendix C