Purge cycle – Bendix Commercial Vehicle Systems AD-IS AIR DRYER AND RESERVOIR SYSTM User Manual

Page 5

Advertising
background image

5

Similarly, the governor also supplies air pressure to the

air dryer. The pressure also moves the air dryer purge

piston down, opening the purge valve to atmosphere and

closing off the compressor air supply to the turbo cut-off

valve (covered in the Turbo Cut-off Feature section of

this document). Water and contaminants captured are

expelled immediately when the purge valve opens. In

addition, air—which was flowing through the desiccant

cartridge—changes direction and begins to flow toward

the open purge valve. Contaminants collected by the air

dryer are removed by air flowing from the purge reservoir

through the desiccant drying bed to the open purge valve.
The initial purge and desiccant cartridge decompression

lasts only a few seconds, evidenced by an audible burst

of air at the air dryer exhaust.

FIGURE 3 -

BENDIX

®

AD-IS

®

AIR DRYER AND RESERVOIR SYSTEM PURGE CYCLE

DIAGRAM SHOWS ALL PRESSURE

PROTECTION VALVES OPEN.

COMPRESSOR

GOVERNOR

DESICCANT

BED

DELIVERY

CHECK VALVE

(CLOSED)

PRIMARY

PORT (PRI)

PURGE VALVE

(OPEN)

TURBO

CUT-OFF

VALVE

(CLOSED)

ENGINE

TURBO

UNLOADER

PORT

SUPPLY

PORT

PRIMARY

RESERVOIR

PRESSURE

PROTECTION

VALVES

AUXILIARY PORTS

(TO ACCESSORIES)

EXHAUST

SAFETY

VALVE

PURGE

RESERVOIR

DRAIN VALVE

SECONDARY

RESERVOIR

SECONDARY

PORT (SEC)

PURGE

RESERVOIR

PURGE

ORIFICE

OIL COALESCING FILTER

(BENDIX

®

AD-IS

®

PURAGUARD

®

OIL COALESCING AIR DRYER)

A

D

C

B

PURGE

CONTROL

CHANNEL

accessories. If the pressure protection valves are preset

to different values the valves will open—in order of lowest

setting to highest setting—when charging a flat system.
The air dryer and purge reservoir will remain in the charge

cycle until the air brake system pressure builds to the

governor cut-out setting of approximately 130 psi.

PURGE CYCLE

(Refer to Figure 3.)

When air brake system pressure reaches the cut-out setting

of the governor, the governor unloads the compressor

activating the purge cycle of the air dryer and reservoir.
The governor unloads the compressor by allowing air

pressure to fill the line leading to the compressor unloader

mechanism. This suspends the delivery of compressed

air to the Bendix

®

AD-IS

®

air dryer and reservoir system.

Advertising