Bendix Commercial Vehicle Systems 16 1/2 SCAM/XTRA LIFE SERV MANUAL - Manual (Page 4)

97 170
IDENTIFICATION
2
The brake assembly may be identified by a tag which is
located on the camshaft bracket cylinder, near the
grease fitting.
The mylar brake assembly tag contains the following:
Dana assembly number, bar coded customer assembly
number, and a numeric customer assembly number.
DAY OF YEAR MODEL YEAR
JULIAN DATE CODE
Two other markings that may be used to identify a
Spicer Brake assembly are located on the assembly's
components. "Spicer" will be cast into the spider
assembly just above the anchor pins. Also, the inside of
the chamber bracket arm contains the following stamped
part information: "Spicer", julian date code, and the part
number.
Brake Assembly Tag
CUSTOMER
ASSEMBLY
NUMBER
CUSTOMER
BAR CODE
NUMBER
165 WD 000 0
MODEL IDENTIFICATION NUMBERING SYSTEM
Alphabetical Code
(i.e., WD = Brake Assembly)
Model (165 = 16.5" Brake)
(150 = 15" Brake)
DANA
ASSEMBLY NUMBER
Sequential Assembly
Numbers
Camshaft Bracket
CHAMBER
BRACKET ARM
STAMPED PART
INFORMATION
BRAKE ASSEMBLY TAG
Camshaft
STAMPED PART
INFORMATION
(IN ONE OF THESE AREAS)
"SPICER"
Spider
BUILD DATE
(APR 1997 AND LATER)