Blackline GPS Loner IS - Manual (Page 12)

10 // USER GUIDE
Charging Loner IS
The charging state can be determined by observing the charging light. See the section
Loner IS Light Behaviour for more detailed information.
1. Plug the Wall Charger into an electrical outlet.
2. Insert the Micro USB Cable Plug into the corresponding Micro USB Charging Jack
on the charging clip
3. Slide the charging clip onto Loner IS using the guides to align the clip with the
charging port on the device.
4. Completely charge Loner IS for 3 hours.
5. Remove the charging clip from Loner IS.
™ Charging Loner IS will turn the device Off ensuring it will not trigger alerts while charg-
ing. Blackline GPS recommends charging Loner IS after each shift to ensure the device
is fully charged for the next shift.
™ WARNING: To reduce the risk of ignition of a flammable atmosphere, batteries must
only be charged in an area known to be nonflammable.
Turning Loner IS On
1. Press the Power Button to turn Loner IS on.
The beeper, alarm status light and vibration motor will annunciate the chirp pat-
tern. The power button indicator light will blink as Loner IS connects to the wireless
network. While Loner IS retains a wireless connection, the power button indicator
light will remain on.
Loner IS needs to have sufficient battery power to connect to the wireless network.
Connection takes approximately one minute.
™ If Loner IS fails to connect to the wireless network, the device will enter the no com-
munication alarm pattern.