Barco R9000901 - Manual (Page 40)

Service Mode
7-3 5975007 BARCOGRAPHICS 808s 160996
Deletion of blocks
This item is password protected.
The delete function is used to clear all data (settings) from an
adjustment block.
A delete can be given :
- block by block
or
- for all blocks.
Deleting block by block
The delete a block function deletes the settings of a selected block.
Highlight 'Delete a block' with the control stick and press
ENTER .
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
<ENTER> to copy
<EXIT> to return.
DELETE MODE
Nr. Src Fh Fv inp conf
1 1 15.6 50 video FC
2 3 31.2 60 RGB3S RT
3 - 15.6 50 intern FC
4 2 31.5 50 RGB3S FC
5 - 33.7 60 intern FC
6
7
8
Active block nr. 1
DELETE BLOCK
The selected block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
Push the control stick forward or backward to select the desired
adjustment block. Press
ENTER to delete the selected adjustment
block. A confirmation menu will be displayed.
ENTER will delete the selected block.
EXIT cancels the deletion procedure and returns to the Service mode
main menu.
Deletion of all blocks
Highlight 'delete all blocks' with the control stick and press ENTER .
ENTER gives a confirmation message before deleting.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
DELETE BLOCK
All block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
If you are certain you wish to delete all blocks, press ENTER to
confirm, otherwise press EXIT to return.
Once ENTER is pressed, all block headers and adjustment settings
are permanently removed and cannot be restored.