Barco R9000901 - Manual (Page 41)

Service Mode
7-4 5975007 BARCOGRAPHICS 808s 160996
Change password
This item is password protected.
Highlight 'change password' with the control stick and press
ENTER .
The current password is displayed. The new password must consist
of 4 digits between 0 and 9. Push the control stick to the left or to the
right to select the digits to be changed. Use the numeric keys to enter
the new digits.
Press ENTER to save the new password. Before saving the new
password, a confirmation screen will be displayed.
Press
EXIT to return to the Service menu without saving the new
password.
Change Language
The 'Change Language' function offers the possibility to change the
language of the screen menus to :
- English
- Spanish
- French
- German
therefore, pusj the control stick forward or backward to highlight
'Change language' and press
ENTER to select the language menu.
Push the control stick forward or backward to select the desired
language and press
ENTER to change the language.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
Use and to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
PASSWORD
Enter new password :
0 0 0 0
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
CHANGE PASSWORD
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
When the displayed password is correct, press ENTER to save.
If not correct, press EXIT to cancel the saving.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
LANGUAGE
ENGLISH
ESPAÑOL
FRANCAIS
DEUTSCH
Select new language
with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Run time
Highlight 'run time' with the control stick and press ENTER to display
the amount of time the projector has played since its first start up at
the factory.
Note : all projectors leave the factory after a burn-in period of
approximately 100 hours.
Press EXIT to return the service mode menu.
RUN TIME
105 h