Barco R9000901 - Manual (Page 47)

Messages, warnings and failure codes
8-2 5975007 BARCOGRAPHICS 808s 160996
WARNING :
go to
stand by
Projector will switch to 'stand-by'
when the RCVDS is no longer
available.
WARNING :
invalid
frequency
input
The entered frequency or ap-
plied frequency of the source is
out of the projector's range.
WARNING :
default
settings
loaded in
the E2PROM
Adjustment settings are lost. Re-
load using Projector Control Soft-
ware via PC or MAC (if this op-
tion is available), or readjust im-
age.
table is
deleted
Message to inform that selected
table is deleted. This message
will be followed by 'confirm mes-
sage', on which the user has to
answer.
FAILURE
invalid
RWI soft
version
Wrong software version in your
projector. Call for technical sup-
port.
FAILURE
I 2 C error
addr. : 7FH3
Hardware failure. Call a quali-
fied service technician for repair.
FAILURE
short
circuit on
I 2 C bus
Hardware failure. Call a quali-
fied service technician for repair.
FAILURE
RCVDS com-
munication
error
Serial communication error be-
tween RCVDS800 and projec-
tor.
FAILURE
RWI commu-
nication
error
Hardware failure. Call a quali-
fied service technician.
FAILURE
IRIS commu-
nication
error
Communication error between
IRIS 800 and the projector. Call
a qualified service technician.
WAIT
starting
up
IRIS
Message during the start up of
the IRIS 800. Message will dis-
appear when the IRIS 800 is
ready to accept commands.