Blomberg GSN 9470 XSP - Manual (Page 39)

38 EN
Lime traces remain on dishes and glassware gains a misty appearance
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse
aid if necessary. Increase the rinse aid setting if there is enough amount of
rinse aid in the machine.
• Water hardness setting is low or salt level is insufficient >>> Measure the
hardness of the supply water appropriately and check the water hardness
setting.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling
hole while adding salt. Make sure that the salt reservoir lid is tightly closed
after finishing the filling process. Run the prewash programme to remove the
salt that spilled inside the machine. Since the salt granules that will remain
under the lid will dissolve during prewash, causing the lid loosen, check the
lid once again at the end of the programme.
There is a different odour in the machine
C
A new machine has a peculiar odour. It will fade out after a couple of
washing.
• Filters are clogged. >>> Check if the filter system is clean. Clean the filter
system regularly as illustrated in section "Cleaning and Care".
• Dirty dishes are kept in dishwasher for 2-3 days. >>> If you are not going
to start the machine right after you have put the dishes into it, remove
the remnants on the dishes and run the Prewash programme without
detergent every 2 days. In such cases, do not close the door of the machine
completely in order to avoid odour build up in machine. You can also use
commercially available odour removers or machine cleaners.