Blomberg GSN 9483 XB20 - Manual (Page 31)

30 EN
machine will fulfill the necessary
operations required to cancel the
programme. Once the Time Delay
function is cancelled, “00:00” will
appear on the Remaining Time
indicator.
C
You can select and operate a
new programme following the
cancellation of the programme.
C
There might be residues of detergent
or rinse aid left in the machine and/
or on the pieces being washed
depending on the step the previous
programme was in at the time of
such cancellation.
Changing a programme
1. Press Start / Pause / Cancel key
to switch the machine into Pause
mode.
2. Select the desired programme by
pressing the Programme Selection
key.
3. Press Start / Pause / Cancel key to
start the new programme.
C
The new programme will start from
the step where the previous one
has stopped. For example, if the
previous programme has remained
in rinsing step, the new programme
will start from the rinsing step as
well. If you want to run the newly
selected programme from the very
beginning, you have to cancel the
programme first and then select a
new programme.
Salt indicator
Check the Salt indicator on the display
to see whether there is enough softening
salt in your machine or not. You need to
refill the salt container whenever the Salt
indicator lights.
C
If the water hardness level is saved
as (r1), Salt indicator will never
come on even if the salt container
is empty. (Adjusting the water
hardness level is explained in
Water Softening System section.)
Rinse Aid indicator
Check the Rinse Aid indicator on the
display to see whether there is enough
softening rinse aid in your machine
or not. You must refill the rinse aid
container when the Rinse Aid indicator
comes on.
C
If the Rinse Aid indicator is set
to OFF, Rinse Aid indicator will
never come on even if the rinse aid
container is empty.
Setting the Rinse Aid indicator
1. Turn on your machine by pressing
On / Off key while pressing and
holding the Half Load ( ) key
when the machine is in off position.
Keep holding the keys pressed in
this stage.
2. Release On / Off (1) key while
pressing and holding the Half Load
( ) key.
3. Keep the Half Load ( ) key
pressed for three seconds more.
4. Rinse Aid indicator lights up and
the Rinse Aid indicator status
saved on your machine appears on
the display as “ON” or “OFF”.
5. You can change the status of the
indicator as “ON” or “OFF” by
pressing the Start / Pause / Cancel
key.
C
If you switch off the machine with
“On/Off" key when the status is
"ON", then the Rinse Aid indicator
will come on when the rinse aid
level in your machine becomes low
while the machine is in use. If you
switch off the machine by pressing
On/Off key when the status is set