Blomberg GSN 9483 XB20 - Manual (Page 35)

34 EN
�
�
�
�
�
�
4. Clean all three filters under tap
water by means of a brush.
5. Replace the metal/plastic filter.
6. Place the coarse filter into the
microfilter. Make sure that it is
properly seated. Turn the coarse
filter clockwise until a “click” sound
is heard.
A
Do not use the dishwasher without
filter.
C
Incorrect placement of the filters
will reduce washing efficiency.
Cleaning the hose filter
Damages on the machine that may be
caused by impurities coming from the
urban supply water or your own water
installation (such as sand, dirt, rust,
etc.) can be prevented by means of the
filter attached to the water inlet hose.
Check the filter and the hose regularly
and clean them if necessary.
1. Turn off the tap and remove the
hose.
2. After taking out the filter, clean it
under running tap water.
3. Place the cleaned filter back to its
seat in the hose.
4. Install the hose to tap.
�
�
�
�
�
�
�
�
�
�
�
�
3. Press the two pawls on the coarse
filter inwards and separate the
coarse filter from the assembly (C).
Cleaning the impellers
Clean the impellers at least once a
week in order for the machine operates
efficiently.
Lower impeller
Check if the holes on the lower impeller
(1) are clogged. If they are clogged,
remove and clean the impeller. Pull the
lower impeller up to remove it (A, B).