Blomberg TKF 8451 WZ GC 50 - Manual (Page 6)

6 EN
2 Installation
Refer to the nearest Authorized Service
Agent for installation of the product.
To make the product ready for use,
make sure that the electricity and water
drainage system are appropriate before
calling the Authorized Service Agent. If
they are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the product's
location as well as the electrical and
waste water installations is under
customer's responsibility.
B
Installation and electrical connections
of the product must be carried out
by the Authorized Service Agent.
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorized persons.
A
Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products cause risks for your safety.
A
Let your dryer wait for 12 hours
before starting to use it.
Appropriate installation
location
• Install the product on a stable and
level surface.
• Dryer is heavy. Do not move it by
yourself.
• Operate your product in a well
ventilated, dust-free environment.
• Do not block the air ducts in front of
and under the product with materials
such as long pile rugs, wooden
blocks and bands.
• Do not install the product behind a
door with a lock, sliding door or a
hinged door which can strike the
product.
• Once the product is installed, it
should stay at the same place where
its connections have been made.
When installing the product, make
sure that the rear wall of it does
not touch anywhere (tap, socket,
etc.). Also pay attention to select an
installation location which you will not
be required to change afterwards.
• Place the product at least 1.5
cm away from the edges of other
furniture.
B
Do not place the product on the
power cable.
Removing the transportation
safety assembly
A
Remove the transportation safety
assembly before using the product for
the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum
that contains a piece of styrofoam.
Hold it from its section marked with
XX XX.
3. Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
Make sure that no part of the
transportation safety assembly
remains inside the drum.
Under counter installation
• This product can be installed under a
counter if the height of the counter is
sufficient.