Blomberg TKF 8451 SGC 30 - Manual (Page 20)

20 EN
5 Maintenance and cleaning
Service life of the product extends and frequently faced
problems decrease if cleaned at regular intervals.
B
This product must be unplugged during
maintenance and cleaning works (control panel,
body, etc.).
Lint Filter / Loading Door Inner Surface
Lint and fibres released from the laundry to the air
during the drying cycle are collected in the Lint Filter.
C
*Such fibre and lint are generally formed during
wearing and washing.
A
Always clean the lint filter and the inner surfaces of
the loading door after each drying process.
C
You can clean the lint filter housing with a vacuum
cleaner.
To clean the lint filter:
1. Open the loading door.
2. Remove the lint filter by pulling it up and open the
lint filter.
3. Clean lint, fibre, and cotton raveling by hand or
with a soft piece of cloth.
4. Close the lint filter and place it back into its
housing.
C
A layer can build up on the lint filter pores that
can cause clogging of the lint filter after using the
machine for a while. Wash the lint filter with warm
water to remove the layer that builds up on the lint
filter surface. Dry the lint filter completely before
reinstalling it.
C
Clean the entire inner surface of the loading door
and loading door gasket.
Cleaning the sensors
There are dampness sensors in the machine that detect
whether the laundry is dry or not.
To clean the sensors:
1. Open the loading door of the machine.
2. Allow the machine to cool down if it is still hot due