Blomberg TKF 8451 SGC 30 - Manual (Page 5)

5 EN
2 Installation
Refer to the nearest Authorized Service Agent for
installation of the product. To make the product ready for
use, make sure that the electricity and water drainage
system are appropriate before calling the Authorized
Service Agent. If they are not, call a qualified technician
and plumber to have any necessary arrangements
carried out.
C
Preparation of the product's location as well as the
electrical and waste water installations is under
customer's responsibility.
B
Installation and electrical connections of the
product must be carried out by the Authorized
Service Agent. Manufacturer shall not be held
liable for damages that may arise from procedures
carried out by unauthorized persons.
A
Prior to installation, visually check if the product
has any defects on it. If so, do not have it installed.
Damaged products cause risks for your safety.
A
Let your dryer wait for 12 hours before starting to
use it.
Appropriate installation location
• Install the product on a stable and level surface.
• Dryer is heavy. Do not move it by yourself.
• Operate your product in a well ventilated, dust-free
environment.
• Do not block the air ducts in front of and under
the product with materials such as long pile rugs,
wooden blocks and bands.
• Do not install the product behind a door with a
lock, sliding door or a hinged door which can strike
the product.
• Once the product is installed, it should stay at
the same place where its connections have been
made. When installing the product, make sure
that the rear wall of it does not touch anywhere
(tap, socket, etc.). Also pay attention to select an
installation location which you will not be required
to change afterwards.
• Place the product at least 1.5 cm away from the
edges of other furniture.
B
Do not place the product on the power cable.
Removing the transportation safety
assembly
A
Remove the transportation safety assembly before
using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that contains
a piece of styrofoam. Hold it from its section
marked with XX XX.
3. Pull the nylon towards yourself and remove the
transportation safety assembly.
A
Make sure that no part of the transportation safety
assembly remains inside the drum.
Under counter installation
• This product can be installed under a counter if the
height of the counter is sufficient.
A
While using undercounter dryer, it should never be
operated without undercounter installation part.
Dryer Depth 60 cm 54 cm
Stock number
of under-bench
installation part
2979700100 2973600100
• Leave at least 3 cm of space around the sides and
the rear wall of the product when installing it under
a counter or in a cupboard.
Mounting over a washing machine
• A fixing device should be used between the two
machines when installing the dryer above a
washing machine. The fixing device (2977200100
white/2977200400 grey) must be installed by the
Authorized Service Agent.
• Total weight of the washing machine and the
dryer -with full load- when they are placed on top
of each other reaches to approx. 180 kilograms.
Place the products on a solid floor that has
sufficient load carrying capacity!
Connecting to the drain
In products equipped with condenser unit, water
accumulates in the water tank during the drying cycle.
You should drain accumulated water after each drying
cycle.
You can directly drain accumulated water through the