Blomberg TKF 8451 SGC 30 - Manual (Page 21)

21 EN
to the drying process.
3. Wipe the metal surfaces of the sensor with a soft
cloth, dampened with vinegar and dry them.
C
Clean metal surfaces of the sensors 4 times a
year.
C
Do not use metal tools when cleaning metal
surfaces of the sensors.
A
Never use solvents, cleaning agents or similar
substances for cleaning due to the risk of fire and
explosion!
Draining the water tank
Dampness of the laundry is removed and condensed
during drying process and the water that arise
accumulates in the water tank. Drain the water tank
after each drying cycle.
A
Condensed water is not potable!
A
Never remove the water tank when the programme
is running!
If you forget to drain the water tank, the machine will
stop during the subsequent drying cycles when the
water tank is full and the Water Tank warning symbol
will flash. If this is the case, drain the water tank and
press Start / Pause / Cancel button to resume the drying
cycle.
To drain the water tank:
1. Pull the drawer and remove the water tank
carefully.
2. Drain the water in the tank.
3. If there is lint accumulation in the funnel of the
water tank, clean it under running water.
4. Place the water tank into its seat.
Cleaning the filter drawer
Lint and fibre that could not be captured by the lint
filter are blocked in the filter drawer behind the kick
plate. Filter Drawer Cleaning warning light will light up
maximum at every 5 drying cycles as a reminder.
There is a two-level filter in the filter drawer. The first
level is the filter drawer sponge and the second level is
the filter cloth.
To clean the filter drawer:
1. Press the kick plate button to open the kick plate.
2. Remove the filter drawer cover by turning it in the
direction of arrow.
3. Pull out the filter drawer.