Blomberg GEN 12400 X - Manual (Page 10)

10 | EN
Installation and connection
• For installation the appliance must be
connected in accordance with all local
gas and/or electrical regulations.
Connection to the mains supply
Important
This appliance must be earthed!
Our company shall not held
responsible for any damage
caused by using the appliance
without an earthed socket.
DANGER
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and the
appliance is only guaranteed after
correct installation.
DANGER
Risk of electric shock, short
circuit or fire by damage of the
mains lead!
The mains lead must not be
clamped, bent or trapped or come
into contact with hot parts of the
appliance.
If the mains lead is damaged, it
must be replaced by a qualified
electrician.
• The mains supply data must
correspond to the data specified on
the rating plate of the appliance. The
rating plate is located at the rear
housing of the appliance.
• The appliance mains cable must
correspond to the specifications and
the power consumption; see Technical
Data, page 5
.
Important
The plug should be easily
accessible after installation (but not
above the hob).
Plug the mains lead into the socket.
DANGER
Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from the
mains supply.
Connection to the gas supply
DANGER
Risk of explosion or poisoning
by unprofessional installation.
The appliance may be connected
to the gas distribution system only
by an authorized qualified person.
DANGER
Risk of explosion!
Before starting any work on the
gas installation, please shut off the
gas supply.
• Pressure and type of the gas supplied
from the local distribution center must
correspond to the data specified on
the rating plate or gas type indication
label of the unit.
NOTICE
Your appliance is adjusted for LP
gas.