Bunn T6A - Manual (Page 9)

Page 9
TROUBLESHOOTING (cont.)
PROBLEM PROBABLE CAUSE REMEDY
Brew cycle will not start (cont.)
Water is not hot
Dilution cycle will not start
5. Start Switch
6. Brew Timer
7. Brew Solenoid Valve
8. Internal Flow control (.195 GPM)
1. Limit Thermostat
CAUTION - Do not eliminate or by-
pass limit thermostat or thermal
cut-off. Use only BOM replacement
part #29329.1000
2. Control Thermostat
3. Tank Heater
1. (A) ON/OFF Switch (T3)
(B) Selector Switch (T6)
2. Start Switch
3. Dilution Timer
Refer to Service - Start Switch for
testing procedures. See page 26
Refer to Service - Brew Timer for
testing procedures. See page 17 or
18
Refer to Service - Brew Solenoid
Valve for testing procedures. See
page 15
(A) Direction of flow arrow must be
pointing towards brewer.
(B) Remove the flow control and
check for obstructions. Clear or re-
place.
Refer to Service - Limit Thermostat
for testing procedures. See page 23
Refer to Service - Control Thermo-
stat for testing procedures. See
page 20
Refer to Service - Tank Heater for
testing procedures. See page 27
Refer to Service - ON/OFF Switch
for testing procedures. See page 24
Refer to Service - Selector Switch
for testing procedures. See page 24
Refer to Service - Start Switch for
testing procedures. See page 26
Refer to Service - Dilution Timer for
testing procedures. See page 22
10145 072600