Brandmotion 1008-9527-V2 - Manual

INSTALLATION INSTRUCTIONS
9527 Instructions 6-18-12 F series-1 (1).doc 1 of 38
Rear Vision System – Tailgate Emblem Camera Mirror Display
2009-Current Ford F-150 and 2010-Current
Super Duty
(Kit part number 1008-9527)
Kit Contents: Tools Required:
Mirror
Tailgate Emblem Mount with Camera
Interior (shorter) Harness
Chassis (longer) Harness
1 bag containing: Ford Emblem
1 bag containing
2 Tailgate emblem retainers
2 Mounting Screws
2 Foam pieces (if needed and optional)
1 bag containing:
25 Wire Ties (short)
7 pairs of T-taps (optional)
(Splice, solder & heat shrink recommended.)
Z-Tech (in a white bottle)
1 bag containing:
3 Templates (along with these instructions)
2 Wire Ties (long and optional)
T20 and T30 Torx Drivers
7mm, 8mm, and 10mm Sockets
Flat Head Screwdriver
Phillips Screwdriver
Plastic Trim Removal tool
Drill Bit and small Flat File
1 inch and 1¾ inch Center Hole Saws
Soldering Iron
Small brush
Round file (if needed)
Mirror removal tool # OTC8200
(Required for non-screw type mirrors)
Deburring Tool
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest
full color instructions, as well as an installation video (use relevant portions of 1008-9520),
please visit www.brandmotion.com
PRE-INSTALLATION VEHICLE CHECKLIST
Before beginning, determine how the vehicle is equipped and check appropriate boxes:
Determine whether the vehicle has an opening in the center of pickup bed close to opposite of the opening in the
bottom of the tailgate.
Yes, skip Section 2.
No, tailgate must be removed to drill an opening for the camera harness (refer to Section 2).
Determine whether the vehicle has the required three mounting holes behind the existing tailgate emblem. Refer to
Steps 1 & 2 to remove inner tailgate panel, and use supplied 1008-9100-03 template to confirm whether the required
holes are present in the panel.
No, use supplied 1008-9100-03 template to position the holes to drill and/or cut the tailgate. If you do not wish to
cut the tailgate, Brandmotion offers tailgate handle camera kits (1008-9520, black handle and 1008-9525,
chrome handle) that do not require cutting.
Yes, proceed to Section 3.
□
Vehicle does NOT have an auto dimming inside mirror (refer to Section 8).
Determine the connector style used on the existing inside rearview mirror:
7-pin or 16-pin. For past models additional information, please see Section 11B (reference).
□
Check kit contents are complete against the list above.