Brandmotion 1008-9527-V2 - Manual (Page 16)

INSTALLATION INSTRUCTIONS
9527 Instructions 6-18-12 F series-1 (1).doc 16 of 38
Section 8: Inside Rear View Mirrors without Auto Dimming
(if required)
Follow the steps in section 8 only if the vehicle does not have an auto
dimming inside rear view mirror.
46. Remove the passenger side door sill
plate with a trim tool and remove passenger
side kick panel with hands, just disengaging
the two clips from the sheet metal (Figure
31).
Figure 31
47. Isolate the seven wires near the black
16-pin mirror connector on the supplied
interior harness with electrical tape along
with the red and yellow wires near the white
6-pin connector.
48. Route the supplied interior harness
green, pink, and black wires along the vehicle
cross dash harness as shown in figure 32.
Secure using wire ties wherever possible at 2
inch intervals.
49. Splice the green reverse wire from the
supplied interior harness white 6-pin
connector end to the wire listed in Diagram
A, on the next page, depending on the
vehicle model. Solder and cover the
connection with tape or heat shrink tubing.
50. Attach the black ground wire eyelet
from the supplied interior harness white 6-pin
connector end to sheet metal in the
passenger side kick panel with a screw using
an 8mm socket (Figure 32).
Figure 32
51. Splice the pink ignition wire from the
supplied interior harness white 6-pin
connector end to the wire listed in Diagram
A, on the next page, depending on the
vehicle model. Solder and cover the
connection with tape or heat shrink tubing.