Bully Dog 84010 Rapid Flow Exhaust System - Manual (Page 5)

4
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 84010
Remove the muffler and front section: The muffler and connected tubing which also connects to
the catalytic converter are removed in a single piece.
1. Locate the area along the exhaust just behind the catalytic converters. Notice that the
exhaust system can be disconnected just behind the catalytic converts on the drivers side and
passenger side. Use a 14mm hand wrench to loosen the nut and bolt holding the exhaust
onto the catalytic converter. save all of the hardware and reuse the hardware on the new
systems.
2. Notice that there is a gasket between the exhaust piece and the catalytic converter; save this gasket
because it needs to be reused for the install of the Bully Dog Exhaust system.
If the gasket material is worn out and will no
longer facilitate a good seal, a new gasket can
be purchased at an OEM dealer or the gasket
can be replaced by cutting out a gasket using
an exhaust rated gasket material.
Disconnect Exhaust from Catalytic Converter
Save the Gaskets and Hardware
REmoVinG thE stoCk Exhaust systEm
14mm