Calculated Industries 6425-C - Manual (Page 10)

8 — DigiRoller
™
Plus II
Height — Stores a height value (rolled or entered) for
calculating cubic volumes and wall areas. The height
value will carry over to the next room area, unless
changed by the user.
Volume — Calculates volume measurements from
entered or stored length, width, and height values.
AutoCount Mode — Places the unit in “AutoCount”
Mode, allowing you to program a fixed distance to be
automatically counted at each occurrence. The DigiRoller
™
Plus II will automatically increase the count each time
it reaches the distance you have set (for example,
it will count the number of times you roll five feet),
and show the number of times it has measured this
distance on the upper left of the display.
Light Key — Turns the display back-light on or off.
Preferences
[Set] [Light] — Scrolls through the DigiRoller
™ Plus II
Preference Settings, which include:
— Bell On/Off
— Wheel Size
— LCD Contrast Control
— Calibration and Percentage Calibration
(Detailed use of each of these preference settings are
discussed later in the guide.)
6425-UG-C 4/4/03 12:44 PM Page 10