Calculated Industries 6425-C - Manual (Page 29)

User’s Guide — 27
Continue the above steps for each area you wish to calculate and
store, up to nine areas.
If you try to store a tenth value, the word “FULL” will display. Press
[RESET]
to clear this error message. If you want to add this last value, you
must then delete and/or edit the values stored in the Area Number
registers. See the “Editing Stored Measurements” section (page 29) for
information on editing values in the Area Number registers.
Recalling Stored Measurements
To review your stored areas, press [Rcl] [Area#]. The last Area Number
measurement that you stored or recalled will be displayed. Once you
press these two keys, you can review all stored values for each Area
Number – length, width, height, area, volume, wall area and totals
for each.
Step: Key:
Area# 1 [Rcl] [Area#] (until Area# 1 appears)
Recall length [L]
Recall width [W]
Recall area [LxW]
6425-UG-C 4/4/03 12:44 PM Page 29