Calculated Industries 6020 v2.0 - Manual (Page 13)

Using the Counter
You can use the [Subtract/Count] key
to count items such as electrical outlets,
drains, etc.
Press [Mode] until you find the Count
mode. Then press the [Subtract/Count]
key to count the items.
You can use the [M1+] and [M2x]
memory keys to store or accumulate
the counts for two different items. After
you have a count value, press [M1+] or
[M2x]
to store it.
Error/Auto-Range Function
Error Message – Press [Reset] to clear to any errors.
Auto Range Function – When calculating large num-
bers, your answer will be displayed in the next
largest measurement unit (ex: 10,000 M will display
instead of 10,000,000 MM ).
Interference
Exposure to direct light or close proximity to cell
phones and other electronic devices may cause in-
terference with the Scale Master device and result in
erroneous measurements.
Automatic Shut-Off
The unit will shut itself off if it is not used for 5 min-
utes. Press any key to restore power. All
registers/settings remain intact.
A
PPENDIX
13 – User’s Guide
6020UG-EFS-C 6/27/03 2:19 PM Page 13