Calculated Industries 6020 v2.0 - Manual (Page 17)

Software Copyrighted and licensed to
Calculated Industries by
Scale Master Technologies, LLC, 2003
User’s Guide copyrighted by
Calculated Industries, 2003
Scale Master ® and Calculated Industries ® are
registered trademarks of Calculated Industries, Inc.
ALL RIGHTS RESERVED.
Designed in the United States of America.
Printed in Indonesia.
17 – User’s Guide
CI MAKES NO WARRANTY OR REPRESENTATION, EITHER
EXPRESS OR IMPLIED, WITH RESPECT TO THE PROD-
UCT’S QUALITY, PERFORMANCE, MERCHANTABILITY, OR
FITNESS FOR A PARTICULAR PURPOSE. AS A RESULT,
THIS PRODUCT, INCLUDING BUT NOT LIMITED TO,
KEYSTROKE PROCEDURES, MATHEMATICAL ACCURACY
AND PREPROGRAMMED MATERIAL, IS SOLD “AS IS,”
AND YOU THE PURCHASER ASSUME THE ENTIRE RISK
AS TO ITS QUALITY AND PERFORMANCE.
IN NO EVENT WILL CI BE LIABLE FOR DIRECT, INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES
RESULTING FROM ANY DEFECT IN THE PRODUCT OR ITS
DOCUMENTATION.
The warranty, disclaimer, and remedies set forth above are
exclusive and replace all others, oral or written, expressed
or implied. No CI dealer, agent, or employee is authorized
to make any modification, extension, or addition to this
warranty. Some states do not allow the exclusion or
limitation of implied warranties or liability for incidental or
consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you
specific rights, and you may also have other rights, which
vary, from state to state.
Disclaimer
6020UG-EFS-C 6/27/03 2:19 PM Page 17