Calculated Industries 6020 v2.0 - Manual (Page 5)

5 – User’s Guide
Adjusting the Wheel
To adjust the Celcon ® polymer wheel,
take a small, flat-head jeweler’s screw-
driver and slightly rotate the screw
near the wheel tip. Rotating the screw
between 1 ⁄4 to 1 ⁄ 3 turn should adjust
the wheel between free spinning
(which is too loose) to skidding (which
is too tight).
“Rolling” a Measurement
To take a measurement with the Scale
Master Classic:
1)
Switch the unit on. Press [Reset] to
clear the display.
2) Select your mode of scale by press-
ing the [Mode] key. Then press the
[Scale] key to select your scale.
3) Begin rolling. The display will reg-
ister your measurements.
To ensure accurate measurements,
be sure to hold the unit upright
and start and stop the SMC at the
exact points you are measuring.
4) Press the appropriate key if you
want to store this measurement
(ex. [M1+] to store as length, [M2x]
to store as width).
5) Press [Reset] to reset the unit and
begin a new measurement.
U SING THE
S
CALE
M
ASTER ® C
LASSIC
6020UG-EFS-C 6/27/03 2:19 PM Page 5