Clay Paky CP COLOR 150 (CDM 150W) User Manual

Page 5

Advertising
background image

5

I

GB

D

E

F

Installazione proiettore - Figura 5
ATTENZIONE: Sfruttare sempre tutti e 4 i fori presenti sulla base dell’apparecchio in caso di installazione a parete o a soffitto.
Ad eccezione di quando il proiettore è posizionato a pavimento, il montaggio della fune di sicurezza è obbligatorio, questa deve essere assicurata alla struttura di sostegno del
proiettore e quindi agganciata agli appositi fori presenti sui fianchi del proiettore stesso.

Regolazione proiettore - Figura 6

Installing the projector - Fig. 5
WARNING: Always use all 4 holes present in the base of the projector for wall or ceiling installations.
With the exception of when the projector is positioned on the floor, the safety chain must be fitted. This must be securely fixed to the support structure of the projector and then
hooked through the special holes in the sides of the projector itself.

Positioning the projector - Fig. 6

Installation du projecteur - Figure 5
ATTENTION: Toujours utiliser les 4 trous présents sur la base de l’appareil.
Excepté quand le projecteur est positionné au sol, le montage du câble de sécurité est obligatoire, celui-ci doit être assuré à la structure de soutien du projecteur, puis attaché aux
trous prévus à cet effet situés sur les côtés du projecteur.

Réglage projecteur - Figure 6

Installation des Projektors - Abb. 5
ACHTUNG: Immer alle 4 Bohrungen auf dem Sockel des Geräts benutzen.
Wenn der Projektor nicht auf dem Fußboden aufgestellt wird, ist die Montage des Sicherheitsseils obligatorisch. Dieses muss an der Haltevorrichtung des Projektors abgesichert
und folglich in die dafür bestimmten Bohrungen an den Seiten des Projektors eingehängt sein.

Einstellung des Projektors - Abb. 6

Instalación del proyector - Figura 5
ATENCIÓN: Utilice siempre los 4 orificios presentes en la base del aparato.
Salvo cuando el proyector se instala en el piso, el montaje de la cuerda de seguridad es obligatorio, la cual se deberá fijar a la estructura de soporte del proyector y enganchar a
los especiales orificios presentes en los lados del mismo proyector.

Regulación del proyector - Figura 6

Continua / Continue

INSTALLAZIONE E MESSA IN FUNZIONE

INSTALLATION AND START-UP

INSTALLATION ET MISE EN FONCTION

INSTALLATION UND INBETRIEBNAHME

INSTALACION Y PUESTA EN FUNCION

I

GB

D

E

F

CP COLOR 150

CP COLOR 150

CP COLOR 150

CP COLOR 150

1

2

5

6

Advertising
This manual is related to the following products: