Clay Paky A.LEDA WASH K20 TW (C61411) User Manual
Page 17
17
A.LEDA WASH CC TW W
DMX ADDRESS
NOTE: without the DMX signal the Address (XXX) flashing
Allows you to select the DMX ADDRESS.
1) Press
F
- the current DMX Adress appear on the display.
2) Use the UP
B
and DOWN
C
, RIGHT
E
keys to plan the DMX
Address.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
FIXTURE ID
Allows you to select the FIXTURE ID.
1) Press
F
- the current Fixture ID appear on the display.
2) Use the UP
B
, DOWN
C
, RIGHT
E
keys to plan the Fixture ID.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
PAN / TILT
Invert pan
Used for reversing Pan movement.
1) Press
F
- the current settings appear on the display (On or Off).
2) Use the UP
B
and DOWN
C
keys to enable (On) or disable (Off)
PAN inversion.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
Invert tilt
Used for reversing tilt movement.
1) Press
F
- the current settings appear on the display (On or Off).
2) Use the UP
B
and DOWN
C
keys to enable (On) or disable (Off)
Tilt inversion.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
Swap Pan-Tilt
Used for swapping Pan and Tilt channels (as well as Pan fine and Tilt fine).
1) Press
F
- the current settings appear on the display (On or Off).
2) Use the UP
B
and DOWN
C
keys to enable (On) or disable (Off)
Pan and Tilt channel swap.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
Encoder Pan-Tilt
Used for enabling the Pan / Tilt encoders.
1) Press
F
- the current settings appear on the display (On or Off).
2) Use the UP
B
and DOWN
C
keys to enable (On) or disable (Off)
Pan / Tilt encoders.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
SILENT MODE
Lets you set an operator mode choosing from the two available:
• Standard: Maximum speed and consequently maximum effect and
fan noise.
• Quiet: reduces the speed of some effects and fans thus also
reducing noise.
DIMMER CUT-OFF
Used to set a DMX fine value under which the dimmer remains to zero
level.
1) Press
F
- the current Dimmer cut-off appear on the display.
2) Use the UP
B
and DOWN
C
, RIGHT
E
keys to plan the Dimmer
cut-off.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
DISPLAY
Used for automatically reduce brightness on the display after about
30 seconds in idle.
1) Press
F
- the current settings appear on the display (On or Off).
2) Use the UP
B
and DOWN
C
keys to enable (On) or disable
(Off) the decreasing of display brightness.
3) Press
F
to confirm the selection or LEFT
D
to keep current settings.
SET UP MENU
OPTIONS MENU
NOTE: On grey the default options
Set Up
Dmx
Address
Fixture ID
Address xxx
Value xxx
Swap
Pan-Tilt
On
Off
Encoder
Pan-Tilt
On
Off
Pan / Tilt
Option
Invert
Pan
On
Off
Invert
Tilt
On
Off
On
Off
Display
Silent
mode
Standard
Quiet
Dimmer
cut-off
Continue
➔