Clay Paky A.LEDA WASH K20 TW (C61411) - Manual (Page 19)

19 A.LEDA WASH CC TW W
OPTION DEFAULT
Invert Pan Off
Invert Tilt Off
Swap Pan-Tilt Off
Encoder Pan-Tilt On
Silent Mode Standard
Display Off
Pan/Tilt speed Normal
Dimmer Curve Curve 3
RGB Gamma Gamma 2.0
SYSTEM ERRORS
Shows a list of warnings and messages relevant to errors occurred since
the fixtures switching-on.
1) Pressing
F you are allowed to reset the SYSTEM ERRORS list.
A confirmation message (Are you sure you want to clear error list ?)
appears on the display.
2) Select YES to reset the list or NO to go back.
FIXTURE HOURS
Used for displaying projector operating hours (total and partial).
1) Press
F - Hours total and partial appears on the display.
Total counter
Counts the number of projector working life hours (from manufacture to date).
Partial counter
Counts the number of partial projector working life hours since the last
reset to date.
2) Press F to reset partial projector working hours a confirmation
message (Are you sure?) appears on the display.
3) Select YES to reset partial projectors counter or NO to keep the current
setting and return to the top menu level.
LED ENERGY TOT
Lets you view total LED working hours.
1) Press
F - to display total and partial Watts/hour:
Total
Total LED working hours from construction to date.
Partial
LED working hours from last reset to date.
2) Press F to reset the partial counter. A confirmation appears on the
screen (Are you sure?)
3) Select YES to reset the partial counter or NO to keep the current setting
and open the next menu level.
SYSTEM VERSION
Used for displaying the software and hardware version of each board
installed in the projector.
CPU brd (CPU board)
Led board
BOARD DIAGNOSTIC
Used for displaying the status error of each board installed in the projector:
Led board
DMX MONITOR
Used for displaying the projector DMX channel level in bit (Val) and in
percentage (Perc).
FANS MONITOR
Used for displaying the speed of each fan installed in the projector:
PwrSp (fan PSU)
Head (fan head)
RDM DEVICE UID
Shows the exclusive address of the fixture to use communicate via RDM.
INFORMATION MENU
Information
System
Errors
Fixture
Hours
Total XXX
Partial XXX
Reset...
Dmx
Monitor
Board Status Err%
Led brd Good 0.00
Fans
Monitor
Fan Speed (RPM)
PwrSp XXXX
Head XXXX
RDM
Device UID
Board
Diagnost.
System
Version
Board Revis. Hw.rv.
CPU brd x.x.x x.x
com.dev x.x
Led brd x.x
LED Energy
Tot
Continue ➔