Bel Canto Design E.ONE DAC3.5VB - Manual (Page 10)

IMPORTANT: When using the DAC3.5 VB MKII directly into a power amplifier, ensure that the Fixed/Variable
Output button is in the OUT (variable) position. Operation in Fixed Mode directly into the amplifier could
cause extreme output levels, clipping and damage to the loudspeakers, amplifiers or your ears!
• 12VDC VB power interconnect jack to
interface with either the VBS1 or LNS1
power supplies
• ST Fiber Input operates up to 24/192 data
rate
• TOSLINK input accept any standard plastic
or glass fiber optical TOSLINK cable and
operates up to 24/192 data rate
• SPDIF1 and SPDIF2 accept BNC or RCA
connections from any 75 ohm SPDIF source
and operate to at least 24/192 data rate
• AES/EBU Input accepts any AES/EBU
standard 110 ohm digital source and
operates up to 24/192 data rate
• XLR 5.5Vrms or 7. RCA 2.75Vrms outputs
are used for directly driving a power
amplifier in variable output mode or a
preamplifier input when in fixed output
mode.
• RCA Analog Inputs
• Output Level Button selects Fixed or
Variable Output Mode
• RS232 Connection
When all connections to and from the unit have been made then double check everything before plugging the
DAC3.5
VB MKII into the power source.
The sonic performance of the DAC3.5 VB MKII will begin to stabilize after 100 hours of continuous power up.