Bel Canto Design E.ONE DAC3.5VB - Manual (Page 11)

• The DAC3.5 VB MKII must be powered by either the VBS1 or the LNS1. If using the VBS1, please refer to
the VBS1 User’s Guide for connectivity. If using the LNS1, please read the following
•
The LNS1 is designed to power Bel Canto VB equipped products only. Use of any cable other than the
supplied power interconnect may damage either the LNS1 or VB equipped unit and will void any
warranty. Certain non-VB equipped units can be factory upgraded. To begin the upgrade process, fill out
the RMA form in the Support Section of our website
• When connecting your VB unit to the LNS1, be careful to observe the alignment notches on both units
power receptacles and the power interconnect cable
• When inserting the power interconnect cable, align the notch on the cable end and the alignment teeth on
the outer sleeve to the 12 o’clock position. This will allow the interconnect cable to fully seat and ensure
that the plug mates correctly with the power receptacle
• Once the power interconnect cable is fully seated in the receptacle, lock in the power interconnect cable
by turning the outer sleeve clockwise one quarter turn. Proper seating of the LNS1 cable will ensure safe
and secure operation of the LNS1 and all connected components
• The LNS1 has been designed to run on non-regulated, non-filtered AC Mains. Usage of any additional
isolation or filtration from the AC Mains supply may compromise LNS1 performance