DJI S800 - Manual (Page 11)

©2012 DJI Innovations. All Rights Reserved.
11
Mount Bi-pod
Step1
Step2
(Fix, but not tighten screws)
800HF X1
800BD X4
800AR X2
HC-M2.5X5 X8
Step3
3.0 M2.5X8 x4
HC-M3.0X22 x2
H frame bulges outwards
T frame n otch
Step1: Mount T frame 800TF and base pipe 800BP.
(1) Put nonslip damper 800ND through the base pipe.
(2) Put the base pipe into T frame until the head of nonslip damper is embedded into T frame.
(3) Embed the other nonslip damper into the T frame.
(4) Put silicon rubber damper 800SRD onto both sides of the base pipe.
Step2: Mount H frame800HF and bi-pod drawbars 800BD.
(1) Fix (but not tighten) hexagonal socket head cap screws M2.5×5 (Fig.
①
) to H frame and
bi-pod drawbar (Fig.
①
).
(2) Adjust drawbar and T frame, and fix (but not tighten) hexagonal socket head cap screw
M2.5×5 (Fig.
②
) to drawbar and aluminum ring 800AR.