DJI S800 - Manual (Page 8)

©2012 DJI Innovations. All Rights Reserved.
8
Mount Center Frame
Remove Screws Fix Screws
Step1: Mount IMU module into IMU position in the center frame. Ensure IMU casing is out of touch the
top board edge, as vibration can cause IMU mal-function.
Step2: Please mount DJI Autopilot System parts onto the bottom board (not including GPS modules).
Please remove all the screws from the bottom board first if necessary.
Step3: Connect Autopilot System and receiver. Please refer to DJI WKM User Manual for details.
Step4: Please mount the screws to bottom board, and use adequate screw glue.
Step5: Mount the GPS on the top board with a bracket.
Step6: Configure Autopilot System. Please refer to DJI WKM User Manual .
Notices:

Make sure to mount the IMU module at the IMU position first.

Mount the GPS with a bracket, to avoid interference from center frame power board.

Ensure the USB port of the M.C. outwards for easy access.

Please wire neatly. Make sure wires will not be cut by the edge of frames.
Tips:

Install screws with appropriate strength to prevent damage threads.