4 performing titrations, 1 preparing single determinations, 2 preparing sample series – Metrohm TiNet 2.5 User Manual
Page 48: 3 buttons for titrations
46 • Titrations
TiNet 2.5 Compliant
5.4 Performing
titrations
5.4.1
Preparing single determinations
Before starting single determinations, proceed as follows:
• Connect, switch on and initialize devices (see section 2.1).
• Start TiNet 2.5 Compliant.
• Disable the
Autostart
option on the
Sample data
tab (see section
5.2.1).
• Enter method and sample data on the
Sample data
tab (see section
5.2.1), or
• Enable the
Silo
option on the
Sample data
tab and enter method and
sample data in the silo memory (see section 5.3.1)
5.4.2
Preparing sample series
Before starting single determinations, proceed as follows:
• Connect and initialize devices (see section 2.1).
• Enable the
Autostart
option on the
Sample data
and enter the number
of samples (see section 5.2.1).
• Enter method and sample data on the
Sample data
tab (see section
5.2.1), or
• Enable the
Silo
option on the
Sample data
tab and enter method and
sample data in the silo memory (see section 5.3.1)
5.4.3
Buttons for titrations
The individual buttons in the main window have the following meaning:
Starts the determination. The button is shown gray
when it is not active.
Stops the determination. The button is shown gray
when it is not active. Can also be used as an emer-
gency stop. If a Titrino stops, TiNet must be
stopped manually.
Continues with the determination after hold by
"Wait/Message/Request" block. The button is shown
gray when it is not active.
Start conditioning. The button is shown gray when it
is not active.